Contact

TSP 710 - 2k blanke lak 250ml

TSP 710
Op maat gemaakt voor professionele gebruikers die op zoek zijn naar een SMART-reparatieoplossing. Voor een vlekkeloze afwerking brengt u twee lagen aan met een tussenpoos van 10 minuten. Deze blanke lak biedt een superieure weerstand tegen benzine en UV-straling, wat zorgt voor een lange levensduur zonder te bezwijken onder weersinvloeden.

Voordelen

    • 2K blanke lak voor de professionele gebruiker: een SMART-reparatieoplossing.
    • Breng 2 lagen aan met een interval van 10 minuten om de perfecte, krasvrije afwerking van een spuitpistool te krijgen.
    • Bestand tegen benzine en UV-straling
    • Heeft geen last van weersinvloeden.

Productdetails

Droge opslag
Ja
Vorstbestendig
ja
Nummer
TSP 710
Bewaartoestand
donker
Verkoopeenheid
1
Eenheden per omdoos
6
Eenheden per pallet
696
Minimum Order Quantity
6

Toepassing

Application TSP 710 - Directions for Use:

  1. Surface Preparation: Clean the surface thoroughly to remove any contaminants. Lightly sand (clear coat prep) better adhesion.
  2. Shake Well: Shake the can vigorously for at least 2 minutes after the mixing ball starts rattling.
  3. Activate: Activate the aerosol by pushing the pin on the bottom using the cap, make sure you push down on a flat surface.
  4. Shake Well: Shake vigorously for at least two minutes to mix the components.
  5. Test Spray: Apply to a test surface to evaluate compatibility and finish.
  6. Application: Hold the can 20cm – 30cm (8-12 inches) away from the surface and apply 2-3 light coats, allowing flash-off time of 5 – 10min between layers.
  7. Drying Time: Allow to cure for at least 24 hours for full hardness.
  8. Nozzle Maintenance: Invert can and spray for 2-3 seconds to clear nozzle.
By clicking 'Accept All' you consent that we may collect information about you for various purposes, including: Statistics and Marketing